Product advantages:
- Fully virucidal: comprehensively effective against enveloped and non-enveloped viruses
- Can be used for noroviruses
- Pleasant fresh smell
- Aldehyde-free concentrate
- Cost-saving due to low application concentration
Product details:
| Function: |
Cleaning and disinfection of surfaces
|
| Effectiveness: |
Against bacteria, yeasts and all viruses (virucidal against enveloped and non-enveloped viruses). |
| Areas of application: |
For all work areas with an increased risk of infection |
| Areas of application: |
Infection ward, intensive care unit, dialysis unit, accident ward, outpatient department, laboratory, etc. |
| Designation: |
Surface disinfection, wipe disinfection, surface disinfection, concentrate
|
| Scope of delivery: |
1 liter B15 or 10 liters B15
|
| Notes: |
Please note the information in the Downloads section |
Other product features:
- VAH list, IHO disinfectant list. Tested according to DVV/RKI guideline, EN 13727, EN 13624, EN 14348, EN 14476, EN 13697, EN 1276, EN 1650, 4-field test according to VAH and EN 16615
- According to VAH:
- 1% solution, 15 minutes contact time
2% solution, 5 minutes contact time
Effective against all viruses in 5 minutes at 2% solution.
- In the food sector according to EN 1276, EN 1650, EN 13697: high load (2%) 15 min. low load (1%) 15 min.
APPLICATION
B 10 is used as a 2% solution. For 10 L of working solution
Dilute 200 ml of B10 with cold water to make 10 L. Apply the B10 ready-to-use solution to a cloth and thoroughly wet the surfaces.
Wipe down surfaces and objects to be disinfected and
Allow the preparation to take effect. Clean visibly contaminated areas with the
Disinfect with the ready-to-use solution and absorb any contamination. Disinfect cleaned surfaces again. Ensure even coverage.
Pay attention to the treated areas. The concentration-time relationship.
According to VAH (German Association for Applied Hygiene), the bactericidal/yeasticidal efficacy is 2% for 5 minutes. Tuberculocidal efficacy is achieved at 2% for 60 minutes. Inactivation
Virus elimination takes place at 2% - 15 min. to 30 min. Use oro® nonwoven wipes standard / compact soaked with B 10 (2%) analogously. Cleaning and wipe disinfection must be carried out daily in all areas where infections are present.
which may be exposed to or which must be protected from contamination. Do not mix B 10 with other products.
The suitability of B 10 for waterproof materials depends on the individual case.
Check. Observe the manufacturer's instructions regarding material compatibility, care and preparation of the surfaces to be disinfected.
B 10 is not suitable for use on aluminium and other alkali-sensitive surfaces, as well as on polycarbonate and
Polycarbonate blends. Product color may vary.
Odors may develop, especially when stored in sunlight.
However, this change in color or smell has no effect on
The product's disinfection performance. Use only by qualified personnel. All information related to the product
Any serious incidents that occur must be reported immediately.
to the manufacturer and the competent authority of your Member State
report.
PRODUCT COMPOSITION
B 10 works on the basis of quaternary ammonium compounds. 100
g contain 4.4 g dimethyldioctylammonium chloride, 0.6 g benzyldimethyl-dodecylammonium chloride, non-ionic surfactants (5 - 15
%), alkaline cleaning components (5 - 15%), complexing agents
(< 5%), butylphenylmethylpropional, citral, geraniol, limonene,
Linalool, fragrance and excipients in aqueous solution.
Use disinfectants carefully.
Always read the label and product information before use.
